ad-block

Advertising seems to be blocked by your browser.

The ads help us provide this software and web site to you for free.

Please support our project by allowing our site to show ads.





Hewlett-Packard photosmart 140 series DOT4USB - two ways of downloading and installing the driver


photosmart 140 series DOT4USB is a USB Universal Serial Bus device. The Windows version of this driver was developed by Hewlett-Packard. The hardware id of this driver is usb/vid_03f0&pid_1002&mi_01.

1. Install Hewlett-Packard photosmart 140 series DOT4USB driver manually


  1. You can download from the link below the driver setup file for the Hewlett-Packard photosmart 140 series DOT4USB driver. The archive contains version 10.1.1.9 dated 2011-04-14 of the driver.
  2.  
  3. Start the driver installer file from a user account with administrative rights. If your User Access Control (UAC) is started please accept of the driver and run the setup with administrative rights.
  4.  
  5. Go through the driver installation wizard, which will guide you; it should be pretty easy to follow. The driver installation wizard will analyze your PC and will install the right driver.
  6.  
  7. When the operation finishes shutdown and restart your PC in order to use the updated driver. As you can see it was quite smple to install a Windows driver!
  8.  
There is no digital signature available for this driver.

This driver was installed by many users and received an average rating of 3.6 stars out of 71174 votes.




2. How to install Hewlett-Packard photosmart 140 series DOT4USB driver using DriverMax


The most important advantage of using DriverMax is that it will setup the driver for you in the easiest possible way and it will keep each driver up to date, not just this one. How can you install a driver with DriverMax? Let's follow a few steps!

  1. Open DriverMax and click on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your computer.
  2.  
  3. Take a look at the list of detected driver updates. Search the list until you locate the Hewlett-Packard photosmart 140 series DOT4USB driver. Click the Update button.
  4.  
  5. That's all, the driver is now installed!
  6.  

Drivers

ad-block

Advertising seems to be blocked by your browser.

The ads help us provide this software and web site to you for free.

Please support our project by allowing our site to show ads.