FTDI microHAM USB Interface KW how to download and install the driver

microHAM USB Interface KW is a USB Universal Serial Bus hardware device. This Windows driver was developed by FTDI. In order to make sure you are downloading the exact right driver the hardware id is USB/VID_0403&PID_EEE8.

1. FTDI microHAM USB Interface KW driver - how to install it manually

1. You can download from the link below the driver setup file for the FTDI microHAM USB Interface KW driver. The archive contains version 2.06.00 dated 2009-10-22 of the driver.
2.  
3. Run the driver installer file from a user account with the highest privileges (rights). If your User Access Control Service (UAC) is enabled please accept of the driver and run the setup with administrative rights.
4.  
5. Follow the driver installation wizard, which will guide you; it should be quite easy to follow. The driver installation wizard will scan your computer and will install the right driver.
6.  
7. When the operation finishes restart your computer in order to use the updated driver. As you can see it was quite smple to install a Windows driver!
8.  

This driver is not digitally signed.

This driver was installed by many users and received an average rating of 3.5 stars out of 37650 votes.

2. How to use DriverMax to install FTDI microHAM USB Interface KW driver

The most important advantage of using DriverMax is that it will setup the driver for you in just a few seconds and it will keep each driver up to date, not just this one. How can you install a driver using DriverMax? Let's follow a few steps!

1. Start DriverMax and push on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your PC.
2.  
3. Take a look at the list of detected driver updates. Scroll the list down until you locate the FTDI microHAM USB Interface KW driver. Click on Update.
4.  
5. Finished installing the driver!
6.