Tacx VR_interface how to download and install the driver

VR_interface is a Jungo device. The Windows version of this driver was developed by Tacx. USB/VID_3561&PID_1932 is the matching hardware id of this device.

1. Install Tacx VR_interface driver manually

1. Download the setup file for Tacx VR_interface driver from the location below. This is the download link for the driver version 9.3.0 released on 2010-07-13.
2.  
3. Run the driver setup file from a Windows account with the highest privileges (rights). If your User Access Control (UAC) is running then you will have to confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Go through the driver installation wizard, which should be pretty straightforward. The driver installation wizard will analyze your PC for compatible devices and will install the driver.
6.  
7. Shutdown and restart your PC and enjoy the new driver, as you can see it was quite smple.
8.  

This driver is not digitally signed.

This driver was installed by many users and received an average rating of 4 stars out of 61189 votes.

2. How to install Tacx VR_interface driver using DriverMax

The most important advantage of using DriverMax is that it will install the driver for you in just a few seconds and it will keep each driver up to date. How easy can you install a driver with DriverMax? Let's follow a few steps!

1. Start DriverMax and press on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your computer.
2.  
3. Take a look at the list of detected driver updates. Scroll the list down until you locate the Tacx VR_interface driver. Click the Update button.
4.  
5. That's all, the driver is now installed!
6.