Genesys Logic USB Mass Storage Device how to download and install the driver

USB Mass Storage Device is a USB Universal Serial Bus device. This driver was developed by Genesys Logic. In order to make sure you are downloading the exact right driver the hardware id is USB/VID_11B0&PID_6548.

1. Install Genesys Logic USB Mass Storage Device driver manually

1. You can download from the link below the driver installer file for the Genesys Logic USB Mass Storage Device driver. The archive contains version 4.1.0.0 dated 2012-04-11 of the driver.
2.  
3. Run the driver installer file from a user account with the highest privileges (rights). If your User Access Control Service (UAC) is enabled please accept of the driver and run the setup with administrative rights.
4.  
5. Go through the driver setup wizard, which will guide you; it should be quite easy to follow. The driver setup wizard will scan your PC and will install the right driver.
6.  
7. When the operation finishes restart your computer in order to use the updated driver. It is as simple as that to install a Windows driver!
8.  

This driver is digitally signed by Genesys Logic.
Size of this driver: 1718058 bytes (1.64 MB)
This driver received an average rating of 4.8 stars out of 98921 votes.
This driver was released for the following versions of Windows:

• This driver works on Windows 2000 64 bits
• This driver works on Windows Server 2003 64 bits
• This driver works on Windows XP 64 bits
• This driver works on Windows Vista 64 bits
• This driver works on Windows 7 64 bits
• This driver works on Windows 8 64 bits
• This driver works on Windows 8.1 64 bits
• This driver works on Windows 10 64 bits
• This driver works on Windows 11 64 bits

2. The easy way: using DriverMax to install Genesys Logic USB Mass Storage Device driver

The most important advantage of using DriverMax is that it will setup the driver for you in the easiest possible way and it will keep each driver up to date, not just this one. How can you install a driver with DriverMax? Let's see!

1. Open DriverMax and press on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your PC.
2.  
3. Take a look at the list of driver updates. Scroll the list down until you find the Genesys Logic USB Mass Storage Device driver. Click on Update.
4.  
5. That's it, you installed your first driver!
6.