Genesys Logic USB Mass Storage Device - two ways of downloading and installing the driver

USB Mass Storage Device is a USB Universal Serial Bus device. This Windows driver was developed by Genesys Logic. USB/VID_05E3&PID_0720 is the matching hardware id of this device.

1. Install Genesys Logic USB Mass Storage Device driver manually

1. Download the driver setup file for Genesys Logic USB Mass Storage Device driver from the location below. This is the download link for the driver version 1.0.0.0 dated 2009-03-05.
2.  
3. Run the driver setup file from a Windows account with the highest privileges (rights). If your User Access Control Service (UAC) is running then you will have to accept of the driver and run the setup with administrative rights.
4.  
5. Follow the driver installation wizard, which should be pretty easy to follow. The driver installation wizard will analyze your PC for compatible devices and will install the driver.
6.  
7. Shutdown and restart your PC and enjoy the new driver, as you can see it was quite smple.
8.  

This driver is digitally signed.
File size of the driver: 25721 bytes (25.12 KB)
This driver received an average rating of 4.2 stars out of 86942 votes.
This driver is fully compatible with the following versions of Windows:

• This driver works on Windows 2000 32 bits
• This driver works on Windows Server 2003 32 bits
• This driver works on Windows XP 32 bits
• This driver works on Windows Vista 32 bits
• This driver works on Windows 7 32 bits
• This driver works on Windows 8 32 bits
• This driver works on Windows 8.1 32 bits
• This driver works on Windows 10 32 bits
• This driver works on Windows 11 32 bits

2. Using DriverMax to install Genesys Logic USB Mass Storage Device driver

The advantage of using DriverMax is that it will setup the driver for you in just a few seconds and it will keep each driver up to date, not just this one. How easy can you install a driver with DriverMax? Let's take a look!

1. Start DriverMax and press on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your computer.
2.  
3. Take a look at the list of driver updates. Scroll the list down until you find the Genesys Logic USB Mass Storage Device driver. Click the Update button.
4.  
5. That's it, you installed your first driver!
6.