Download and install National Instruments USB Flash Firmware Updater driver

USB Flash Firmware Updater is a DAQ Device hardware device. The Windows version of this driver was developed by National Instruments. USB/VID_3923&PID_735B&REV_0100&MI_00 is the matching hardware id of this device.

1. Install National Instruments USB Flash Firmware Updater driver manually

1. Download the driver setup file for National Instruments USB Flash Firmware Updater driver from the location below. This is the download link for the driver version 22.5.0.49247 dated 2022-07-07.
2.  
3. Start the driver setup file from a Windows account with administrative rights. If your User Access Control Service (UAC) is enabled then you will have to confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Follow the driver installation wizard, which should be quite easy to follow. The driver installation wizard will scan your PC for compatible devices and will install the driver.
6.  
7. Shutdown and restart your PC and enjoy the new driver, as you can see it was quite smple.
8.  

There is no digital signature available for this driver.
Download size of the driver: 0 bytes (0 B)
Driver rating 3.2 stars out of 66439 votes.

2. The easy way: using DriverMax to install National Instruments USB Flash Firmware Updater driver

The most important advantage of using DriverMax is that it will setup the driver for you in just a few seconds and it will keep each driver up to date. How can you install a driver using DriverMax? Let's follow a few steps!

1. Open DriverMax and click on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your PC.
2.  
3. Take a look at the list of detected driver updates. Search the list until you find the National Instruments USB Flash Firmware Updater driver. Click the Update button.
4.  
5. That's it, you installed your first driver!
6.