National Instruments USB DAQ - two ways of downloading and installing the driver

USB DAQ is a DAQ Device device. This Windows driver was developed by National Instruments. The hardware id of this driver is USB/VID_3923&PID_7599&REV_0100&MI_00.

1. How to manually install National Instruments USB DAQ driver

1. You can download from the link below the driver installer file for the National Instruments USB DAQ driver. The archive contains version 22.8.0.49361 dated 2022-10-02 of the driver.
2.  
3. Run the driver installer file from a user account with the highest privileges (rights). If your User Access Control (UAC) is started please confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Follow the driver setup wizard, which will guide you; it should be pretty easy to follow. The driver setup wizard will scan your computer and will install the right driver.
6.  
7. When the operation finishes shutdown and restart your computer in order to use the updated driver. As you can see it was quite smple to install a Windows driver!
8.  

This driver is not digitally signed.

This driver received an average rating of 3.7 stars out of 78086 votes.

2. Using DriverMax to install National Instruments USB DAQ driver

The most important advantage of using DriverMax is that it will install the driver for you in just a few seconds and it will keep each driver up to date. How easy can you install a driver with DriverMax? Let's follow a few steps!

1. Start DriverMax and press on the yellow button named ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your computer.
2.  
3. Take a look at the list of detected driver updates. Search the list until you locate the National Instruments USB DAQ driver. Click on Update.
4.  
5. That's all, the driver is now installed!
6.