National Instruments USB-6361 Mass Termination - two ways of downloading and installing the driver

USB-6361 Mass Termination is a DAQ Device hardware device. The Windows version of this driver was developed by National Instruments. USB/VID_3923&PID_759D&REV_0100 is the matching hardware id of this device.

1. Install National Instruments USB-6361 Mass Termination driver manually

1. You can download from the link below the driver setup file for the National Instruments USB-6361 Mass Termination driver. The archive contains version 22.5.0.49247 dated 2022-07-07 of the driver.
2.  
3. Run the driver installer file from a user account with administrative rights. If your User Access Control (UAC) is started please confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Go through the driver installation wizard, which will guide you; it should be quite easy to follow. The driver installation wizard will scan your PC and will install the right driver.
6.  
7. When the operation finishes shutdown and restart your PC in order to use the updated driver. It is as simple as that to install a Windows driver!
8.  

There is no digital signature available for this driver.
File size of the driver: 0 bytes (0 B)
This driver received an average rating of 3.5 stars out of 83522 votes.

2. Installing the National Instruments USB-6361 Mass Termination driver using DriverMax: the easy way

The advantage of using DriverMax is that it will setup the driver for you in just a few seconds and it will keep each driver up to date, not just this one. How easy can you install a driver with DriverMax? Let's follow a few steps!

1. Start DriverMax and push on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your computer.
2.  
3. Take a look at the list of available driver updates. Scroll the list down until you locate the National Instruments USB-6361 Mass Termination driver. Click the Update button.
4.  
5. Finished installing the driver!
6.