Aquantia Solo 10G SFP Thunderbolt 2 Edition - two ways of downloading and installing the driver

Solo 10G SFP Thunderbolt 2 Edition is a Network Adapters device. This Windows driver was developed by Aquantia. PCI/VEN_1D6A&DEV_80B1&SUBSYS_72E716B8&REV_02 is the matching hardware id of this device.

1. Install Aquantia Solo 10G SFP Thunderbolt 2 Edition driver manually

1. Download the driver setup file for Aquantia Solo 10G SFP Thunderbolt 2 Edition driver from the location below. This download link is for the driver version 2.1.008.0 dated 2018-07-04.
2.  
3. Run the driver setup file from a Windows account with the highest privileges (rights). If your User Access Control Service (UAC) is running then you will have to confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Go through the driver setup wizard, which should be quite straightforward. The driver setup wizard will scan your PC for compatible devices and will install the driver.
6.  
7. Restart your computer and enjoy the fresh driver, it is as simple as that.
8.  

This driver is digitally signed by the manufacturer.
Size of this driver: 1076407 bytes (1.03 MB)
This driver received an average rating of 4.8 stars out of 68174 votes.
This driver was released for the following versions of Windows:

• This driver works on Windows 7 64 bits
• This driver works on Windows 8 64 bits
• This driver works on Windows 8.1 64 bits
• This driver works on Windows 10 64 bits
• This driver works on Windows 11 64 bits

2. How to use DriverMax to install Aquantia Solo 10G SFP Thunderbolt 2 Edition driver

The advantage of using DriverMax is that it will install the driver for you in just a few seconds and it will keep each driver up to date, not just this one. How can you install a driver with DriverMax? Let's take a look!

1. Start DriverMax and press on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your computer.
2.  
3. Take a look at the list of available driver updates. Scroll the list down until you locate the Aquantia Solo 10G SFP Thunderbolt 2 Edition driver. Click on Update.
4.  
5. Finished installing the driver!
6.