Driver for Phoenix Contact Silicon Labs CP210x USB to UART Bridge - downloading and installing it

Silicon Labs CP210x USB to UART Bridge is a Ports device. This driver was developed by Phoenix Contact. In order to make sure you are downloading the exact right driver the hardware id is USB/VID_10C4&PID_EA60.

1. How to manually install Phoenix Contact Silicon Labs CP210x USB to UART Bridge driver

1. Download the driver setup file for Phoenix Contact Silicon Labs CP210x USB to UART Bridge driver from the link below. This download link is for the driver version 6.6.1.0 released on 2012-12-10.
2.  
3. Start the driver installation file from a Windows account with the highest privileges (rights). If your UAC (User Access Control) is started then you will have to confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Go through the driver installation wizard, which should be quite easy to follow. The driver installation wizard will scan your PC for compatible devices and will install the driver.
6.  
7. Restart your computer and enjoy the new driver, it is as simple as that.
8.  

This driver is digitally signed by the manufacturer.
Size of this driver: 1737207 bytes (1.66 MB)
This driver received an average rating of 4.5 stars out of 57159 votes.
This driver is compatible with the following versions of Windows:

• This driver works on Windows 2000 64 bits
• This driver works on Windows Server 2003 64 bits
• This driver works on Windows XP 64 bits
• This driver works on Windows Vista 64 bits
• This driver works on Windows 7 64 bits
• This driver works on Windows 8 64 bits
• This driver works on Windows 8.1 64 bits
• This driver works on Windows 10 64 bits
• This driver works on Windows 11 64 bits

2. Installing the Phoenix Contact Silicon Labs CP210x USB to UART Bridge driver using DriverMax: the easy way

The most important advantage of using DriverMax is that it will install the driver for you in just a few seconds and it will keep each driver up to date. How can you install a driver using DriverMax? Let's see!

1. Start DriverMax and press on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your computer.
2.  
3. Take a look at the list of detected driver updates. Search the list until you locate the Phoenix Contact Silicon Labs CP210x USB to UART Bridge driver. Click the Update button.
4.  
5. That's it, you installed your first driver!
6.