Syntek STK1160 Grabber - two ways of downloading and installing the driver

STK1160 Grabber is a MEDIA hardware device. This Windows driver was developed by Syntek. USB/Vid_0932&Pid_0300&MI_00 is the matching hardware id of this device.

1. How to manually install Syntek STK1160 Grabber driver

1. You can download from the link below the driver installer file for the Syntek STK1160 Grabber driver. The archive contains version 7.12.000.003 dated 2010-06-07 of the driver.
2.  
3. Run the driver installer file from a user account with administrative rights. If your UAC (User Access Control) is running please confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Go through the driver setup wizard, which will guide you; it should be quite easy to follow. The driver setup wizard will analyze your PC and will install the right driver.
6.  
7. When the operation finishes shutdown and restart your PC in order to use the updated driver. As you can see it was quite smple to install a Windows driver!
8.  

There is no digital signature available for this driver.

This driver received an average rating of 3.1 stars out of 18480 votes.

2. Using DriverMax to install Syntek STK1160 Grabber driver

The most important advantage of using DriverMax is that it will install the driver for you in just a few seconds and it will keep each driver up to date, not just this one. How can you install a driver using DriverMax? Let's follow a few steps!

1. Start DriverMax and press on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your PC.
2.  
3. Take a look at the list of driver updates. Scroll the list down until you locate the Syntek STK1160 Grabber driver. Click on Update.
4.  
5. That's all, the driver is now installed!
6.