Aquantia SANLink3 N1 10Gbit Network Adapter how to download and install the driver

SANLink3 N1 10Gbit Network Adapter is a Network Adapters device. This Windows driver was developed by Aquantia. The hardware id of this driver is PCI/VEN_1D6A&DEV_87B1&SUBSYS_7202105A&REV_02; this string has to match your hardware.

1. Manually install Aquantia SANLink3 N1 10Gbit Network Adapter driver

1. Download the driver setup file for Aquantia SANLink3 N1 10Gbit Network Adapter driver from the location below. This is the download link for the driver version 2.1.008.0 released on 2018-07-04.
2.  
3. Start the driver setup file from a Windows account with administrative rights. If your UAC (User Access Control) is enabled then you will have to accept of the driver and run the setup with administrative rights.
4.  
5. Follow the driver installation wizard, which should be quite straightforward. The driver installation wizard will analyze your PC for compatible devices and will install the driver.
6.  
7. Shutdown and restart your computer and enjoy the new driver, as you can see it was quite smple.
8.  

This driver is digitally signed.
File size of the driver: 1076407 bytes (1.03 MB)
This driver received an average rating of 4.1 stars out of 68095 votes.
This driver will work for the following versions of Windows:

• This driver works on Windows 7 64 bits
• This driver works on Windows 8 64 bits
• This driver works on Windows 8.1 64 bits
• This driver works on Windows 10 64 bits
• This driver works on Windows 11 64 bits

2. The easy way: using DriverMax to install Aquantia SANLink3 N1 10Gbit Network Adapter driver

The advantage of using DriverMax is that it will setup the driver for you in the easiest possible way and it will keep each driver up to date, not just this one. How can you install a driver using DriverMax? Let's see!

1. Open DriverMax and click on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your computer.
2.  
3. Take a look at the list of driver updates. Scroll the list down until you find the Aquantia SANLink3 N1 10Gbit Network Adapter driver. Click the Update button.
4.  
5. That's all, the driver is now installed!
6.