Elnec Remote Control Unit for Stand-Alone Programmers - two ways of downloading and installing the driver

Remote Control Unit for Stand-Alone Programmers is a Dev Pgm USB hardware device. The developer of this driver was Elnec. In order to make sure you are downloading the exact right driver the hardware id is USB/VID_1393&PID_0595.

1. Elnec Remote Control Unit for Stand-Alone Programmers - install the driver manually

1. Download the setup file for Elnec Remote Control Unit for Stand-Alone Programmers driver from the link below. This is the download link for the driver version 2.93.11.0 dated 2012-12-12.
2.  
3. Start the driver setup file from a Windows account with the highest privileges (rights). If your User Access Control Service (UAC) is enabled then you will have to confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Go through the driver setup wizard, which should be quite straightforward. The driver setup wizard will analyze your PC for compatible devices and will install the driver.
6.  
7. Shutdown and restart your PC and enjoy the new driver, as you can see it was quite smple.
8.  

There is no digital signature available for this driver.
Size of this driver: 0 bytes (0 B)
This driver was rated with an average of 3 stars by 97114 users.

2. Installing the Elnec Remote Control Unit for Stand-Alone Programmers driver using DriverMax: the easy way

The advantage of using DriverMax is that it will install the driver for you in the easiest possible way and it will keep each driver up to date. How easy can you install a driver with DriverMax? Let's see!

1. Open DriverMax and press on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your computer.
2.  
3. Take a look at the list of available driver updates. Scroll the list down until you find the Elnec Remote Control Unit for Stand-Alone Programmers driver. Click the Update button.
4.  
5. That's it, you installed your first driver!
6.