Elnec Remote Control Unit V2 for Stand-Alone Programmers - two ways of downloading and installing the driver

Remote Control Unit V2 for Stand-Alone Programmers is a Dev Pgm USB device. This Windows driver was developed by Elnec. The hardware id of this driver is USB/VID_1393&PID_2312.

1. Elnec Remote Control Unit V2 for Stand-Alone Programmers - install the driver manually

1. Download the driver setup file for Elnec Remote Control Unit V2 for Stand-Alone Programmers driver from the link below. This is the download link for the driver version 3.59.01.00 released on 2020-05-25.
2.  
3. Start the driver installation file from a Windows account with the highest privileges (rights). If your UAC (User Access Control) is enabled then you will have to confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Follow the driver setup wizard, which should be quite straightforward. The driver setup wizard will scan your PC for compatible devices and will install the driver.
6.  
7. Restart your PC and enjoy the fresh driver, it is as simple as that.
8.  

This driver is not digitally signed.

Driver rating 3.6 stars out of 31127 votes.

2. Using DriverMax to install Elnec Remote Control Unit V2 for Stand-Alone Programmers driver

The most important advantage of using DriverMax is that it will setup the driver for you in just a few seconds and it will keep each driver up to date, not just this one. How easy can you install a driver using DriverMax? Let's see!

1. Open DriverMax and press on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your computer.
2.  
3. Take a look at the list of driver updates. Scroll the list down until you find the Elnec Remote Control Unit V2 for Stand-Alone Programmers driver. Click on Update.
4.  
5. Enjoy using the updated driver! :)
6.