Download and install Elnec Remote Control Unit V2 for Stand-Alone Programmers driver

Remote Control Unit V2 for Stand-Alone Programmers is a Dev Pgm USB device. The Windows version of this driver was developed by Elnec. USB/VID_1393&PID_2312 is the matching hardware id of this device.

1. Elnec Remote Control Unit V2 for Stand-Alone Programmers - install the driver manually

1. You can download from the link below the driver setup file for the Elnec Remote Control Unit V2 for Stand-Alone Programmers driver. The archive contains version 2.93.11.0 released on 2012-12-12 of the driver.
2.  
3. Start the driver installer file from a user account with administrative rights. If your UAC (User Access Control) is running please confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Go through the driver setup wizard, which will guide you; it should be pretty easy to follow. The driver setup wizard will analyze your PC and will install the right driver.
6.  
7. When the operation finishes shutdown and restart your computer in order to use the updated driver. It is as simple as that to install a Windows driver!
8.  

This driver is not digitally signed.
Size of this driver: 0 bytes (0 B)
Driver rating 4 stars out of 8934 votes.

2. Installing the Elnec Remote Control Unit V2 for Stand-Alone Programmers driver using DriverMax: the easy way

The most important advantage of using DriverMax is that it will install the driver for you in just a few seconds and it will keep each driver up to date, not just this one. How easy can you install a driver with DriverMax? Let's see!

1. Open DriverMax and press on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your computer.
2.  
3. Take a look at the list of available driver updates. Scroll the list down until you find the Elnec Remote Control Unit V2 for Stand-Alone Programmers driver. Click the Update button.
4.  
5. That's all, the driver is now installed!
6.