REINER SCT REINER SCT cyberJack RFID standard - two ways of downloading and installing the driver

REINER SCT cyberJack RFID standard is a Smart Card Reader hardware device. The developer of this driver was REINER SCT. In order to make sure you are downloading the exact right driver the hardware id is USB/VID_0C4B&PID_0500.

1. Manually install REINER SCT REINER SCT cyberJack RFID standard driver

1. Download the setup file for REINER SCT REINER SCT cyberJack RFID standard driver from the location below. This is the download link for the driver version 6.0.8.5 dated 2014-12-18.
2.  
3. Run the driver setup file from a Windows account with the highest privileges (rights). If your User Access Control Service (UAC) is enabled then you will have to confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Follow the driver setup wizard, which should be quite straightforward. The driver setup wizard will analyze your PC for compatible devices and will install the driver.
6.  
7. Shutdown and restart your PC and enjoy the new driver, it is as simple as that.
8.  

This driver was not digitally signed.

This driver received an average rating of 3.9 stars out of 88295 votes.

2. Using DriverMax to install REINER SCT REINER SCT cyberJack RFID standard driver

The most important advantage of using DriverMax is that it will setup the driver for you in just a few seconds and it will keep each driver up to date. How can you install a driver using DriverMax? Let's follow a few steps!

1. Open DriverMax and press on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your PC.
2.  
3. Take a look at the list of detected driver updates. Search the list until you locate the REINER SCT REINER SCT cyberJack RFID standard driver. Click the Update button.
4.  
5. Enjoy using the updated driver! :)
6.