Download and install Network Connect Network Connect HS-USB WWAN Adapter driver

Network Connect HS-USB WWAN Adapter is a Network Adapters device. This driver was developed by Network Connect. In order to make sure you are downloading the exact right driver the hardware id is USB/VID_2020&PID_2064&MI_04.

1. Manually install Network Connect Network Connect HS-USB WWAN Adapter driver

1. Download the setup file for Network Connect Network Connect HS-USB WWAN Adapter driver from the location below. This download link is for the driver version 5.0.0.0 released on 2018-02-05.
2.  
3. Start the driver installation file from a Windows account with administrative rights. If your User Access Control Service (UAC) is running then you will have to accept of the driver and run the setup with administrative rights.
4.  
5. Go through the driver installation wizard, which should be pretty straightforward. The driver installation wizard will analyze your PC for compatible devices and will install the driver.
6.  
7. Restart your PC and enjoy the fresh driver, as you can see it was quite smple.
8.  

This driver is digitally signed.
Size of this driver: 232725 bytes (227.27 KB)
This driver was rated with an average of 4.8 stars by 60796 users.
This driver is fully compatible with the following versions of Windows:

• This driver works on Windows 7 32 bits
• This driver works on Windows 8 32 bits
• This driver works on Windows 8.1 32 bits
• This driver works on Windows 10 32 bits
• This driver works on Windows 11 32 bits

2. How to use DriverMax to install Network Connect Network Connect HS-USB WWAN Adapter driver

The advantage of using DriverMax is that it will install the driver for you in just a few seconds and it will keep each driver up to date, not just this one. How easy can you install a driver with DriverMax? Let's follow a few steps!

1. Open DriverMax and push on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your PC.
2.  
3. Take a look at the list of detected driver updates. Search the list until you locate the Network Connect Network Connect HS-USB WWAN Adapter driver. Click on Update.
4.  
5. That's all, the driver is now installed!
6.