Download and install National Instruments National Instruments SMBus Controller driver

National Instruments SMBus Controller is a NISMBus hardware device. The Windows version of this driver was developed by National Instruments. In order to make sure you are downloading the exact right driver the hardware id is PCI/VEN_8086&DEV_27DA&SUBSYS_71F91093.

1. Install National Instruments National Instruments SMBus Controller driver manually

1. Download the driver setup file for National Instruments National Instruments SMBus Controller driver from the link below. This download link is for the driver version 14.0.0.49157 dated 2014-06-04.
2.  
3. Start the driver installation file from a Windows account with administrative rights. If your UAC (User Access Control) is started then you will have to accept of the driver and run the setup with administrative rights.
4.  
5. Go through the driver setup wizard, which should be quite straightforward. The driver setup wizard will scan your PC for compatible devices and will install the driver.
6.  
7. Restart your computer and enjoy the updated driver, as you can see it was quite smple.
8.  

This driver is not digitally signed.
The file size of this driver is 0 bytes (0 B)
This driver was rated with an average of 3.7 stars by 77745 users.

2. Using DriverMax to install National Instruments National Instruments SMBus Controller driver

The advantage of using DriverMax is that it will install the driver for you in just a few seconds and it will keep each driver up to date. How can you install a driver using DriverMax? Let's follow a few steps!

1. Start DriverMax and click on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your PC.
2.  
3. Take a look at the list of detected driver updates. Search the list until you locate the National Instruments National Instruments SMBus Controller driver. Click on Update.
4.  
5. Finished installing the driver!
6.