Obsidian Control Systems NX4 Programmer Module driver download and installation

NX4 Programmer Module is a USBDevice hardware device. The Windows version of this driver was developed by Obsidian Control Systems. USB/VID_11BE&PID_E101 is the matching hardware id of this device.

1. Manually install Obsidian Control Systems NX4 Programmer Module driver

1. You can download from the link below the driver installer file for the Obsidian Control Systems NX4 Programmer Module driver. The archive contains version 16.6.43.737 dated 2022-08-04 of the driver.
2.  
3. Run the driver installer file from a user account with administrative rights. If your User Access Control (UAC) is running please accept of the driver and run the setup with administrative rights.
4.  
5. Go through the driver setup wizard, which will guide you; it should be quite easy to follow. The driver setup wizard will analyze your PC and will install the right driver.
6.  
7. When the operation finishes restart your PC in order to use the updated driver. As you can see it was quite smple to install a Windows driver!
8.  

There is no digital signature available for this driver.

Driver rating 3 stars out of 50560 votes.

2. How to use DriverMax to install Obsidian Control Systems NX4 Programmer Module driver

The most important advantage of using DriverMax is that it will install the driver for you in just a few seconds and it will keep each driver up to date, not just this one. How can you install a driver using DriverMax? Let's follow a few steps!

1. Open DriverMax and push on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your PC.
2.  
3. Take a look at the list of driver updates. Scroll the list down until you locate the Obsidian Control Systems NX4 Programmer Module driver. Click on Update.
4.  
5. That's all, the driver is now installed!
6.