Download and install Obsidian Control Systems NX4 Programmer Module driver

NX4 Programmer Module is a USBDevice hardware device. The developer of this driver was Obsidian Control Systems. In order to make sure you are downloading the exact right driver the hardware id is USB/VID_11BE&PID_E101.

1. Manually install Obsidian Control Systems NX4 Programmer Module driver

1. You can download from the link below the driver installer file for the Obsidian Control Systems NX4 Programmer Module driver. The archive contains version 12.57.59.264 released on 2023-04-14 of the driver.
2.  
3. Run the driver installer file from a user account with the highest privileges (rights). If your User Access Control (UAC) is enabled please confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Follow the driver installation wizard, which will guide you; it should be quite easy to follow. The driver installation wizard will analyze your computer and will install the right driver.
6.  
7. When the operation finishes restart your PC in order to use the updated driver. It is as simple as that to install a Windows driver!
8.  

This driver is not digitally signed.

This driver was installed by many users and received an average rating of 3.2 stars out of 55962 votes.

2. Using DriverMax to install Obsidian Control Systems NX4 Programmer Module driver

The most important advantage of using DriverMax is that it will setup the driver for you in just a few seconds and it will keep each driver up to date. How can you install a driver with DriverMax? Let's follow a few steps!

1. Start DriverMax and push on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your PC.
2.  
3. Take a look at the list of driver updates. Scroll the list down until you locate the Obsidian Control Systems NX4 Programmer Module driver. Click on Update.
4.  
5. That's it, you installed your first driver!
6.