Download and install National Instruments NI cRIO-9111 driver

NI cRIO-9111 is a NI-RIO Devices hardware device. The Windows version of this driver was developed by National Instruments. PCI/VEN_1093&DEV_73F6 is the matching hardware id of this device.

1. Install National Instruments NI cRIO-9111 driver manually

1. Download the setup file for National Instruments NI cRIO-9111 driver from the link below. This is the download link for the driver version 14.0.0.49152 released on 2014-06-09.
2.  
3. Start the driver installation file from a Windows account with administrative rights. If your User Access Control Service (UAC) is enabled then you will have to accept of the driver and run the setup with administrative rights.
4.  
5. Go through the driver setup wizard, which should be pretty straightforward. The driver setup wizard will scan your PC for compatible devices and will install the driver.
6.  
7. Shutdown and restart your PC and enjoy the new driver, it is as simple as that.
8.  

There is no digital signature available for this driver.
File size of the driver: 0 bytes (0 B)
This driver received an average rating of 3.9 stars out of 49475 votes.

2. How to use DriverMax to install National Instruments NI cRIO-9111 driver

The advantage of using DriverMax is that it will install the driver for you in just a few seconds and it will keep each driver up to date. How can you install a driver using DriverMax? Let's take a look!

1. Open DriverMax and click on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your computer.
2.  
3. Take a look at the list of detected driver updates. Scroll the list down until you locate the National Instruments NI cRIO-9111 driver. Click on Update.
4.  
5. That's it, you installed your first driver!
6.