National Instruments NI PCI-232/2 Isolated Interface how to download and install the driver

NI PCI-232/2 Isolated Interface is a NI-Serial Peripherals hardware device. The Windows version of this driver was developed by National Instruments. In order to make sure you are downloading the exact right driver the hardware id is PCI/VEN_1093&DEV_D250.

1. Install National Instruments NI PCI-232/2 Isolated Interface driver manually

1. Download the setup file for National Instruments NI PCI-232/2 Isolated Interface driver from the link below. This download link is for the driver version 19.0.0.49152 released on 2019-03-20.
2.  
3. Start the driver installation file from a Windows account with administrative rights. If your User Access Control Service (UAC) is running then you will have to accept of the driver and run the setup with administrative rights.
4.  
5. Go through the driver setup wizard, which should be pretty straightforward. The driver setup wizard will analyze your PC for compatible devices and will install the driver.
6.  
7. Shutdown and restart your PC and enjoy the updated driver, as you can see it was quite smple.
8.  

This driver was not digitally signed.

This driver received an average rating of 3.1 stars out of 61448 votes.

2. How to use DriverMax to install National Instruments NI PCI-232/2 Isolated Interface driver

The most important advantage of using DriverMax is that it will install the driver for you in just a few seconds and it will keep each driver up to date. How easy can you install a driver using DriverMax? Let's see!

1. Start DriverMax and push on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your computer.
2.  
3. Take a look at the list of detected driver updates. Scroll the list down until you locate the National Instruments NI PCI-232/2 Isolated Interface driver. Click on Update.
4.  
5. That's it, you installed your first driver!
6.