Generic USB smartcard reader MultiCard reader 1.0 - two ways of downloading and installing the driver

MultiCard reader 1.0 is a Smart Card Reader hardware device. The Windows version of this driver was developed by Generic USB smartcard reader. USB/VID_1307&PID_0360&MI_00 is the matching hardware id of this device.

1. Generic USB smartcard reader MultiCard reader 1.0 - install the driver manually

1. Download the setup file for Generic USB smartcard reader MultiCard reader 1.0 driver from the link below. This is the download link for the driver version 2.0.0.0 released on 2008-03-03.
2.  
3. Run the driver installation file from a Windows account with the highest privileges (rights). If your User Access Control Service (UAC) is started then you will have to confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Go through the driver setup wizard, which should be quite easy to follow. The driver setup wizard will scan your PC for compatible devices and will install the driver.
6.  
7. Restart your computer and enjoy the fresh driver, as you can see it was quite smple.
8.  

This driver is not digitally signed.
File size of the driver: 0 bytes (0 B)
This driver was rated with an average of 3.2 stars by 19090 users.

2. Using DriverMax to install Generic USB smartcard reader MultiCard reader 1.0 driver

The advantage of using DriverMax is that it will setup the driver for you in just a few seconds and it will keep each driver up to date, not just this one. How can you install a driver with DriverMax? Let's take a look!

1. Open DriverMax and press on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your PC.
2.  
3. Take a look at the list of available driver updates. Scroll the list down until you locate the Generic USB smartcard reader MultiCard reader 1.0 driver. Click the Update button.
4.  
5. That's all, the driver is now installed!
6.