Generic 3D Printer Monoprice Maker Select V2.1 - two ways of downloading and installing the driver

Monoprice Maker Select V2.1 is a Ports hardware device. This driver was developed by Generic 3D Printer. The hardware id of this driver is USB/VID_2E26&PID_271D; this string has to match your hardware.

1. Install Generic 3D Printer Monoprice Maker Select V2.1 driver manually

1. Download the driver setup file for Generic 3D Printer Monoprice Maker Select V2.1 driver from the link below. This is the download link for the driver version 11.37.56.29 dated 2018-09-10.
2.  
3. Run the driver installation file from a Windows account with the highest privileges (rights). If your User Access Control (UAC) is running then you will have to accept of the driver and run the setup with administrative rights.
4.  
5. Go through the driver installation wizard, which should be pretty straightforward. The driver installation wizard will analyze your PC for compatible devices and will install the driver.
6.  
7. Restart your PC and enjoy the updated driver, as you can see it was quite smple.
8.  

This driver is digitally signed.
The file size of this driver is 1068928 bytes (1.02 MB)
This driver received an average rating of 4.7 stars out of 27332 votes.
This driver is fully compatible with the following versions of Windows:

• This driver works on Windows 2000 64 bits
• This driver works on Windows Server 2003 64 bits
• This driver works on Windows XP 64 bits
• This driver works on Windows Vista 64 bits
• This driver works on Windows 7 64 bits
• This driver works on Windows 8 64 bits
• This driver works on Windows 8.1 64 bits
• This driver works on Windows 10 64 bits
• This driver works on Windows 11 64 bits

2. How to use DriverMax to install Generic 3D Printer Monoprice Maker Select V2.1 driver

The advantage of using DriverMax is that it will setup the driver for you in just a few seconds and it will keep each driver up to date. How easy can you install a driver using DriverMax? Let's take a look!

1. Open DriverMax and click on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your PC.
2.  
3. Take a look at the list of available driver updates. Scroll the list down until you locate the Generic 3D Printer Monoprice Maker Select V2.1 driver. Click on Update.
4.  
5. That's it, you installed your first driver!
6.