Mitac Mio DigiWalker SmartPhone USB Sync driver download and installation

Mio DigiWalker SmartPhone USB Sync is a WCEUSBS device. The Windows version of this driver was developed by Mitac. The hardware id of this driver is USB/Vid_3340&Pid_053A.

1. Mitac Mio DigiWalker SmartPhone USB Sync driver - how to install it manually

1. You can download from the link below the driver setup file for the Mitac Mio DigiWalker SmartPhone USB Sync driver. The archive contains version 6.1.6965.0 dated 2007-05-31 of the driver.
2.  
3. Run the driver installer file from a user account with the highest privileges (rights). If your User Access Control Service (UAC) is enabled please confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Go through the driver setup wizard, which will guide you; it should be pretty easy to follow. The driver setup wizard will scan your computer and will install the right driver.
6.  
7. When the operation finishes restart your computer in order to use the updated driver. As you can see it was quite smple to install a Windows driver!
8.  

This driver is not digitally signed.

This driver received an average rating of 4 stars out of 14770 votes.

2. The easy way: using DriverMax to install Mitac Mio DigiWalker SmartPhone USB Sync driver

The advantage of using DriverMax is that it will install the driver for you in just a few seconds and it will keep each driver up to date, not just this one. How can you install a driver using DriverMax? Let's follow a few steps!

1. Open DriverMax and push on the yellow button named ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your PC.
2.  
3. Take a look at the list of driver updates. Scroll the list down until you find the Mitac Mio DigiWalker SmartPhone USB Sync driver. Click the Update button.
4.  
5. That's all, the driver is now installed!
6.