Mitac Mio DigiWalker 338 driver download and installation

Mio DigiWalker 338 is a WCEUSBS device. This Windows driver was developed by Mitac. The hardware id of this driver is USB/Vid_3340&Pid_0426.

1. Install Mitac Mio DigiWalker 338 driver manually

1. Download the setup file for Mitac Mio DigiWalker 338 driver from the link below. This is the download link for the driver version 6.1.6965.0 released on 2007-05-31.
2.  
3. Start the driver setup file from a Windows account with the highest privileges (rights). If your User Access Control Service (UAC) is started then you will have to confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Go through the driver installation wizard, which should be pretty easy to follow. The driver installation wizard will analyze your PC for compatible devices and will install the driver.
6.  
7. Restart your computer and enjoy the updated driver, as you can see it was quite smple.
8.  

This driver was not digitally signed.
Driver file size: 0 bytes (0 B)
This driver was installed by many users and received an average rating of 3.5 stars out of 46691 votes.

2. Using DriverMax to install Mitac Mio DigiWalker 338 driver

The advantage of using DriverMax is that it will install the driver for you in the easiest possible way and it will keep each driver up to date. How can you install a driver with DriverMax? Let's follow a few steps!

1. Start DriverMax and press on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your PC.
2.  
3. Take a look at the list of available driver updates. Scroll the list down until you locate the Mitac Mio DigiWalker 338 driver. Click the Update button.
4.  
5. Enjoy using the updated driver! :)
6.