Mitac Mio DigiWalker 338 - two ways of downloading and installing the driver

Mio DigiWalker 338 is a WCEUSBS device. This Windows driver was developed by Mitac. In order to make sure you are downloading the exact right driver the hardware id is USB/Vid_3340&Pid_0326.

1. How to manually install Mitac Mio DigiWalker 338 driver

1. You can download from the link below the driver setup file for the Mitac Mio DigiWalker 338 driver. The archive contains version 6.1.6965.0 dated 2007-05-31 of the driver.
2.  
3. Start the driver installer file from a user account with the highest privileges (rights). If your User Access Control Service (UAC) is started please accept of the driver and run the setup with administrative rights.
4.  
5. Go through the driver installation wizard, which will guide you; it should be pretty easy to follow. The driver installation wizard will analyze your computer and will install the right driver.
6.  
7. When the operation finishes restart your computer in order to use the updated driver. As you can see it was quite smple to install a Windows driver!
8.  

There is no digital signature available for this driver.
Download size of the driver: 0 bytes (0 B)
This driver was rated with an average of 3.3 stars by 87996 users.

2. The easy way: using DriverMax to install Mitac Mio DigiWalker 338 driver

The most important advantage of using DriverMax is that it will setup the driver for you in the easiest possible way and it will keep each driver up to date, not just this one. How easy can you install a driver with DriverMax? Let's see!

1. Open DriverMax and press on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your PC.
2.  
3. Take a look at the list of driver updates. Scroll the list down until you locate the Mitac Mio DigiWalker 338 driver. Click on Update.
4.  
5. Finished installing the driver!
6.