Driver for Hamrick Software Microtek ScanMaker X12USL - downloading and installing it

Microtek ScanMaker X12USL is a Imaging Devices hardware device. This Windows driver was developed by Hamrick Software. USB/Vid_05da&Pid_20b0 is the matching hardware id of this device.

1. How to manually install Hamrick Software Microtek ScanMaker X12USL driver

1. Download the driver setup file for Hamrick Software Microtek ScanMaker X12USL driver from the link below. This download link is for the driver version 1.0.0.142 dated 2006-08-21.
2.  
3. Run the driver installation file from a Windows account with administrative rights. If your User Access Control (UAC) is enabled then you will have to confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Go through the driver installation wizard, which should be quite straightforward. The driver installation wizard will analyze your PC for compatible devices and will install the driver.
6.  
7. Shutdown and restart your PC and enjoy the new driver, it is as simple as that.
8.  

This driver is not digitally signed.

This driver received an average rating of 3.5 stars out of 15347 votes.

2. How to use DriverMax to install Hamrick Software Microtek ScanMaker X12USL driver

The most important advantage of using DriverMax is that it will setup the driver for you in just a few seconds and it will keep each driver up to date. How can you install a driver using DriverMax? Let's see!

1. Start DriverMax and press on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your PC.
2.  
3. Take a look at the list of detected driver updates. Search the list until you find the Hamrick Software Microtek ScanMaker X12USL driver. Click the Update button.
4.  
5. Enjoy using the updated driver! :)
6.