Hamrick Software Microtek ScanMaker X12USL - two ways of downloading and installing the driver

Microtek ScanMaker X12USL is a Imaging Devices hardware device. This driver was developed by Hamrick Software. The hardware id of this driver is USB/Vid_05da&Pid_20b0.

1. How to manually install Hamrick Software Microtek ScanMaker X12USL driver

1. Download the setup file for Hamrick Software Microtek ScanMaker X12USL driver from the link below. This is the download link for the driver version 1.0.0.137 dated 2006-08-21.
2.  
3. Start the driver setup file from a Windows account with administrative rights. If your User Access Control Service (UAC) is started then you will have to accept of the driver and run the setup with administrative rights.
4.  
5. Go through the driver installation wizard, which should be pretty easy to follow. The driver installation wizard will analyze your PC for compatible devices and will install the driver.
6.  
7. Shutdown and restart your PC and enjoy the new driver, as you can see it was quite smple.
8.  

This driver was not digitally signed.
The file size of this driver is 0 bytes (0 B)
Driver rating 3.7 stars out of 95606 votes.

2. How to install Hamrick Software Microtek ScanMaker X12USL driver using DriverMax

The most important advantage of using DriverMax is that it will install the driver for you in just a few seconds and it will keep each driver up to date, not just this one. How easy can you install a driver using DriverMax? Let's take a look!

1. Start DriverMax and push on the yellow button named ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your PC.
2.  
3. Take a look at the list of detected driver updates. Search the list until you locate the Hamrick Software Microtek ScanMaker X12USL driver. Click on Update.
4.  
5. That's it, you installed your first driver!
6.