Hamrick Software Microtek ScanMaker 9700XL - two ways of downloading and installing the driver

Microtek ScanMaker 9700XL is a Imaging Devices hardware device. The Windows version of this driver was developed by Hamrick Software. In order to make sure you are downloading the exact right driver the hardware id is USB/Vid_05da&Pid_20e0.

1. Hamrick Software Microtek ScanMaker 9700XL - install the driver manually

1. Download the setup file for Hamrick Software Microtek ScanMaker 9700XL driver from the location below. This download link is for the driver version 1.0.0.3 released on 2006-08-21.
2.  
3. Start the driver setup file from a Windows account with the highest privileges (rights). If your UAC (User Access Control) is enabled then you will have to accept of the driver and run the setup with administrative rights.
4.  
5. Follow the driver setup wizard, which should be quite easy to follow. The driver setup wizard will scan your PC for compatible devices and will install the driver.
6.  
7. Shutdown and restart your PC and enjoy the updated driver, as you can see it was quite smple.
8.  

There is no digital signature available for this driver.

This driver was installed by many users and received an average rating of 3.5 stars out of 38137 votes.

2. The easy way: using DriverMax to install Hamrick Software Microtek ScanMaker 9700XL driver

The most important advantage of using DriverMax is that it will install the driver for you in the easiest possible way and it will keep each driver up to date. How easy can you install a driver using DriverMax? Let's see!

1. Start DriverMax and press on the yellow button named ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your PC.
2.  
3. Take a look at the list of detected driver updates. Scroll the list down until you find the Hamrick Software Microtek ScanMaker 9700XL driver. Click on Update.
4.  
5. That's all, the driver is now installed!
6.