Hamrick Software Microtek ScanMaker 4700 - two ways of downloading and installing the driver

Microtek ScanMaker 4700 is a Imaging Devices hardware device. This driver was developed by Hamrick Software. In order to make sure you are downloading the exact right driver the hardware id is USB/Vid_05da&Pid_20b4.

1. Install Hamrick Software Microtek ScanMaker 4700 driver manually

1. Download the driver setup file for Hamrick Software Microtek ScanMaker 4700 driver from the location below. This is the download link for the driver version 1.0.0.127 released on 2006-08-21.
2.  
3. Start the driver installation file from a Windows account with administrative rights. If your User Access Control Service (UAC) is enabled then you will have to accept of the driver and run the setup with administrative rights.
4.  
5. Go through the driver setup wizard, which should be pretty straightforward. The driver setup wizard will analyze your PC for compatible devices and will install the driver.
6.  
7. Restart your computer and enjoy the updated driver, as you can see it was quite smple.
8.  

This driver is not digitally signed.
Download size of the driver: 0 bytes (0 B)
This driver was rated with an average of 3.3 stars by 84383 users.

2. Using DriverMax to install Hamrick Software Microtek ScanMaker 4700 driver

The most important advantage of using DriverMax is that it will install the driver for you in just a few seconds and it will keep each driver up to date, not just this one. How can you install a driver with DriverMax? Let's take a look!

1. Open DriverMax and push on the yellow button named ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your PC.
2.  
3. Take a look at the list of available driver updates. Search the list until you locate the Hamrick Software Microtek ScanMaker 4700 driver. Click the Update button.
4.  
5. That's it, you installed your first driver!
6.