Driver for LSI Corp. LSI Logic MegaRAID SATA 300-4ELP RAID Controller - downloading and installing it

LSI Logic MegaRAID SATA 300-4ELP RAID Controller is a SCSI Adapter device. The developer of this driver was LSI Corp.. In order to make sure you are downloading the exact right driver the hardware id is PCI/VEN_1000&DEV_0411&SUBSYS_20051000.

1. Install LSI Corp. LSI Logic MegaRAID SATA 300-4ELP RAID Controller driver manually

1. Download the setup file for LSI Corp. LSI Logic MegaRAID SATA 300-4ELP RAID Controller driver from the link below. This download link is for the driver version 6.704.12.00 released on 2014-05-30.
2.  
3. Run the driver installation file from a Windows account with administrative rights. If your User Access Control Service (UAC) is enabled then you will have to accept of the driver and run the setup with administrative rights.
4.  
5. Follow the driver installation wizard, which should be quite straightforward. The driver installation wizard will analyze your PC for compatible devices and will install the driver.
6.  
7. Shutdown and restart your PC and enjoy the updated driver, as you can see it was quite smple.
8.  

This driver is not digitally signed.

Driver rating 4 stars out of 61228 votes.

2. Using DriverMax to install LSI Corp. LSI Logic MegaRAID SATA 300-4ELP RAID Controller driver

The most important advantage of using DriverMax is that it will setup the driver for you in just a few seconds and it will keep each driver up to date, not just this one. How easy can you install a driver using DriverMax? Let's follow a few steps!

1. Start DriverMax and click on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your computer.
2.  
3. Take a look at the list of detected driver updates. Scroll the list down until you find the LSI Corp. LSI Logic MegaRAID SATA 300-4ELP RAID Controller driver. Click the Update button.
4.  
5. That's all, the driver is now installed!
6.