Driver for Jabra Jabra STONE2 DFU mode - downloading and installing it

Jabra STONE2 DFU mode is a USB Universal Serial Bus device. This Windows driver was developed by Jabra. In order to make sure you are downloading the exact right driver the hardware id is USB/VID_0B0E&PID_0934.

1. Jabra Jabra STONE2 DFU mode - install the driver manually

1. You can download from the link below the driver installer file for the Jabra Jabra STONE2 DFU mode driver. The archive contains version 2.3.0.0 dated 2011-05-16 of the driver.
2.  
3. Start the driver installer file from a user account with the highest privileges (rights). If your User Access Control Service (UAC) is started please confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Follow the driver installation wizard, which will guide you; it should be quite easy to follow. The driver installation wizard will scan your PC and will install the right driver.
6.  
7. When the operation finishes shutdown and restart your computer in order to use the updated driver. As you can see it was quite smple to install a Windows driver!
8.  

There is no digital signature available for this driver.
Size of this driver: 0 bytes (0 B)
This driver was rated with an average of 3.5 stars by 13691 users.

2. Using DriverMax to install Jabra Jabra STONE2 DFU mode driver

The most important advantage of using DriverMax is that it will setup the driver for you in just a few seconds and it will keep each driver up to date, not just this one. How can you install a driver using DriverMax? Let's follow a few steps!

1. Open DriverMax and push on the yellow button named ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your PC.
2.  
3. Take a look at the list of detected driver updates. Search the list until you locate the Jabra Jabra STONE2 DFU mode driver. Click the Update button.
4.  
5. That's all, the driver is now installed!
6.