SEGGER Microcontroller GmbH J-Link Device WinUSB - two ways of downloading and installing the driver

J-Link Device WinUSB is a USBDevice device. The developer of this driver was SEGGER Microcontroller GmbH. The hardware id of this driver is USB/VID_1366&PID_106c&MI_06; this string has to match your hardware.

1. How to manually install SEGGER Microcontroller GmbH J-Link Device WinUSB driver

1. Download the setup file for SEGGER Microcontroller GmbH J-Link Device WinUSB driver from the location below. This is the download link for the driver version 3.00.00.000 released on 2019-06-14.
2.  
3. Start the driver setup file from a Windows account with the highest privileges (rights). If your UAC (User Access Control) is running then you will have to confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Go through the driver setup wizard, which should be pretty straightforward. The driver setup wizard will analyze your PC for compatible devices and will install the driver.
6.  
7. Shutdown and restart your PC and enjoy the fresh driver, it is as simple as that.
8.  

This driver is digitally signed by SEGGER Microcontroller GmbH.
File size of the driver: 2635020 bytes (2.51 MB)
This driver received an average rating of 4.1 stars out of 98462 votes.
This driver is compatible with the following versions of Windows:

• This driver works on Windows 2000 64 bits
• This driver works on Windows Server 2003 64 bits
• This driver works on Windows XP 64 bits
• This driver works on Windows Vista 64 bits
• This driver works on Windows 7 64 bits
• This driver works on Windows 8 64 bits
• This driver works on Windows 8.1 64 bits
• This driver works on Windows 10 64 bits
• This driver works on Windows 11 64 bits

2. How to use DriverMax to install SEGGER Microcontroller GmbH J-Link Device WinUSB driver

The most important advantage of using DriverMax is that it will install the driver for you in just a few seconds and it will keep each driver up to date, not just this one. How easy can you install a driver with DriverMax? Let's follow a few steps!

1. Start DriverMax and press on the yellow button named ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your PC.
2.  
3. Take a look at the list of available driver updates. Scroll the list down until you locate the SEGGER Microcontroller GmbH J-Link Device WinUSB driver. Click the Update button.
4.  
5. That's all, the driver is now installed!
6.