Driver for SEGGER Microcontroller GmbH J-Link Device WinUSB - downloading and installing it

J-Link Device WinUSB is a USBDevice hardware device. The Windows version of this driver was developed by SEGGER Microcontroller GmbH. USB/VID_1366&PID_1029&MI_00 is the matching hardware id of this device.

1. Install SEGGER Microcontroller GmbH J-Link Device WinUSB driver manually

1. Download the setup file for SEGGER Microcontroller GmbH J-Link Device WinUSB driver from the location below. This is the download link for the driver version 3.00.00.000 dated 2019-06-14.
2.  
3. Run the driver setup file from a Windows account with the highest privileges (rights). If your User Access Control Service (UAC) is started then you will have to accept of the driver and run the setup with administrative rights.
4.  
5. Go through the driver setup wizard, which should be pretty straightforward. The driver setup wizard will analyze your PC for compatible devices and will install the driver.
6.  
7. Restart your PC and enjoy the new driver, as you can see it was quite smple.
8.  

This driver is digitally signed by SEGGER Microcontroller GmbH.
File size of the driver: 2635020 bytes (2.51 MB)
Driver rating 5 stars out of 41875 votes.
This driver is compatible with the following versions of Windows:

• This driver works on Windows 2000 64 bits
• This driver works on Windows Server 2003 64 bits
• This driver works on Windows XP 64 bits
• This driver works on Windows Vista 64 bits
• This driver works on Windows 7 64 bits
• This driver works on Windows 8 64 bits
• This driver works on Windows 8.1 64 bits
• This driver works on Windows 10 64 bits
• This driver works on Windows 11 64 bits

2. How to use DriverMax to install SEGGER Microcontroller GmbH J-Link Device WinUSB driver

The most important advantage of using DriverMax is that it will setup the driver for you in the easiest possible way and it will keep each driver up to date, not just this one. How easy can you install a driver using DriverMax? Let's see!

1. Start DriverMax and click on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your computer.
2.  
3. Take a look at the list of detected driver updates. Scroll the list down until you locate the SEGGER Microcontroller GmbH J-Link Device WinUSB driver. Click on Update.
4.  
5. That's all, the driver is now installed!
6.