Marvell Generic Marvell Yukon 88E8062 based Ethernet Controller - two ways of downloading and installing the driver

Generic Marvell Yukon 88E8062 based Ethernet Controller is a Network Adapters device. The Windows version of this driver was developed by Marvell. In order to make sure you are downloading the exact right driver the hardware id is PCI/VEN_11AB&DEV_4343.

1. Marvell Generic Marvell Yukon 88E8062 based Ethernet Controller - install the driver manually

1. You can download from the link below the driver installer file for the Marvell Generic Marvell Yukon 88E8062 based Ethernet Controller driver. The archive contains version 10.67.3.3 dated 2009-01-08 of the driver.
2.  
3. Run the driver installer file from a user account with administrative rights. If your User Access Control Service (UAC) is enabled please accept of the driver and run the setup with administrative rights.
4.  
5. Go through the driver installation wizard, which will guide you; it should be pretty easy to follow. The driver installation wizard will analyze your computer and will install the right driver.
6.  
7. When the operation finishes restart your computer in order to use the updated driver. It is as simple as that to install a Windows driver!
8.  

This driver was not digitally signed.

This driver received an average rating of 3.5 stars out of 13523 votes.

2. How to use DriverMax to install Marvell Generic Marvell Yukon 88E8062 based Ethernet Controller driver

The most important advantage of using DriverMax is that it will install the driver for you in just a few seconds and it will keep each driver up to date. How can you install a driver with DriverMax? Let's follow a few steps!

1. Open DriverMax and press on the yellow button named ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your computer.
2.  
3. Take a look at the list of detected driver updates. Scroll the list down until you locate the Marvell Generic Marvell Yukon 88E8062 based Ethernet Controller driver. Click on Update.
4.  
5. Finished installing the driver!
6.