Driver for PLANEX COMMUNICATIONS INC GW-USUltra300 MAC1 - downloading and installing it

GW-USUltra300 MAC1 is a Network Adapters device. This driver was developed by PLANEX COMMUNICATIONS INC. In order to make sure you are downloading the exact right driver the hardware id is USB/VID_2019&PID_4904&MI_01.

1. How to manually install PLANEX COMMUNICATIONS INC GW-USUltra300 MAC1 driver

1. Download the driver setup file for PLANEX COMMUNICATIONS INC GW-USUltra300 MAC1 driver from the link below. This is the download link for the driver version 1027.1.0902.2014 dated 2014-10-13.
2.  
3. Run the driver setup file from a Windows account with administrative rights. If your UAC (User Access Control) is enabled then you will have to accept of the driver and run the setup with administrative rights.
4.  
5. Go through the driver setup wizard, which should be quite straightforward. The driver setup wizard will scan your PC for compatible devices and will install the driver.
6.  
7. Restart your PC and enjoy the updated driver, as you can see it was quite smple.
8.  

This driver is digitally signed.
Size of this driver: 1658303 bytes (1.58 MB)
This driver was rated with an average of 4.5 stars by 97474 users.
This driver was released for the following versions of Windows:

• This driver works on Windows 8 64 bits
• This driver works on Windows 8.1 64 bits
• This driver works on Windows 10 64 bits
• This driver works on Windows 11 64 bits

2. How to use DriverMax to install PLANEX COMMUNICATIONS INC GW-USUltra300 MAC1 driver

The most important advantage of using DriverMax is that it will setup the driver for you in just a few seconds and it will keep each driver up to date. How easy can you install a driver with DriverMax? Let's take a look!

1. Start DriverMax and push on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your PC.
2.  
3. Take a look at the list of driver updates. Search the list until you locate the PLANEX COMMUNICATIONS INC GW-USUltra300 MAC1 driver. Click on Update.
4.  
5. That's all, the driver is now installed!
6.