Driver for PLANEX COMMUNICATIONS INC GW-USUltra300 MAC1 - downloading and installing it

GW-USUltra300 MAC1 is a Network Adapters device. The developer of this driver was PLANEX COMMUNICATIONS INC. In order to make sure you are downloading the exact right driver the hardware id is USB/VID_2019&PID_4904&MI_01.

1. PLANEX COMMUNICATIONS INC GW-USUltra300 MAC1 driver - how to install it manually

1. Download the driver setup file for PLANEX COMMUNICATIONS INC GW-USUltra300 MAC1 driver from the link below. This is the download link for the driver version 1021.9.0517.2013 released on 2013-05-17.
2.  
3. Start the driver installation file from a Windows account with administrative rights. If your UAC (User Access Control) is enabled then you will have to accept of the driver and run the setup with administrative rights.
4.  
5. Go through the driver setup wizard, which should be pretty straightforward. The driver setup wizard will analyze your PC for compatible devices and will install the driver.
6.  
7. Shutdown and restart your computer and enjoy the updated driver, as you can see it was quite smple.
8.  

This driver was not digitally signed.

This driver was rated with an average of 3.1 stars by 99326 users.

2. The easy way: using DriverMax to install PLANEX COMMUNICATIONS INC GW-USUltra300 MAC1 driver

The most important advantage of using DriverMax is that it will setup the driver for you in the easiest possible way and it will keep each driver up to date. How can you install a driver using DriverMax? Let's follow a few steps!

1. Open DriverMax and push on the yellow button named ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your PC.
2.  
3. Take a look at the list of available driver updates. Scroll the list down until you locate the PLANEX COMMUNICATIONS INC GW-USUltra300 MAC1 driver. Click the Update button.
4.  
5. That's it, you installed your first driver!
6.