Download and install PLANEX COMMUNICATIONS INC GW-USUltra300 MAC0 driver

GW-USUltra300 MAC0 is a Network Adapters device. The developer of this driver was PLANEX COMMUNICATIONS INC. The hardware id of this driver is USB/VID_2019&PID_4904&MI_00; this string has to match your hardware.

1. PLANEX COMMUNICATIONS INC GW-USUltra300 MAC0 driver - how to install it manually

1. You can download from the link below the driver setup file for the PLANEX COMMUNICATIONS INC GW-USUltra300 MAC0 driver. The archive contains version 1027.4.0630.2015 released on 2015-10-08 of the driver.
2.  
3. Run the driver installer file from a user account with the highest privileges (rights). If your User Access Control Service (UAC) is started please accept of the driver and run the setup with administrative rights.
4.  
5. Go through the driver setup wizard, which will guide you; it should be quite easy to follow. The driver setup wizard will analyze your computer and will install the right driver.
6.  
7. When the operation finishes shutdown and restart your PC in order to use the updated driver. As you can see it was quite smple to install a Windows driver!
8.  

This driver is digitally signed by the manufacturer.
Size of this driver: 1552974 bytes (1.48 MB)
Driver rating 4.5 stars out of 61288 votes.
This driver was released for the following versions of Windows:

• This driver works on Windows 8.1 32 bits
• This driver works on Windows 10 32 bits
• This driver works on Windows 11 32 bits

2. How to install PLANEX COMMUNICATIONS INC GW-USUltra300 MAC0 driver using DriverMax

The advantage of using DriverMax is that it will install the driver for you in just a few seconds and it will keep each driver up to date. How can you install a driver using DriverMax? Let's follow a few steps!

1. Start DriverMax and push on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your computer.
2.  
3. Take a look at the list of detected driver updates. Scroll the list down until you find the PLANEX COMMUNICATIONS INC GW-USUltra300 MAC0 driver. Click the Update button.
4.  
5. That's all, the driver is now installed!
6.