Driver for PLANEX COMMUNICATIONS INC GW-USUltra300 MAC0 - downloading and installing it

GW-USUltra300 MAC0 is a Network Adapters hardware device. The developer of this driver was PLANEX COMMUNICATIONS INC. In order to make sure you are downloading the exact right driver the hardware id is USB/VID_2019&PID_4904&MI_00.

1. PLANEX COMMUNICATIONS INC GW-USUltra300 MAC0 driver - how to install it manually

1. Download the driver setup file for PLANEX COMMUNICATIONS INC GW-USUltra300 MAC0 driver from the link below. This download link is for the driver version 1021.9.0517.2013 dated 2013-05-17.
2.  
3. Start the driver setup file from a Windows account with administrative rights. If your User Access Control (UAC) is enabled then you will have to accept of the driver and run the setup with administrative rights.
4.  
5. Follow the driver installation wizard, which should be quite easy to follow. The driver installation wizard will scan your PC for compatible devices and will install the driver.
6.  
7. Restart your PC and enjoy the new driver, it is as simple as that.
8.  

This driver was not digitally signed.

Driver rating 3.4 stars out of 2296 votes.

2. The easy way: using DriverMax to install PLANEX COMMUNICATIONS INC GW-USUltra300 MAC0 driver

The advantage of using DriverMax is that it will setup the driver for you in the easiest possible way and it will keep each driver up to date, not just this one. How can you install a driver with DriverMax? Let's follow a few steps!

1. Open DriverMax and push on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your PC.
2.  
3. Take a look at the list of detected driver updates. Scroll the list down until you find the PLANEX COMMUNICATIONS INC GW-USUltra300 MAC0 driver. Click on Update.
4.  
5. That's all, the driver is now installed!
6.