Driver for PLANEX COMMUNICATIONS INC GW-USFang300 MAC1 - downloading and installing it

GW-USFang300 MAC1 is a Network Adapters hardware device. This driver was developed by PLANEX COMMUNICATIONS INC. In order to make sure you are downloading the exact right driver the hardware id is USB/VID_2019&PID_4903&REV_0000&MI_01.

1. Manually install PLANEX COMMUNICATIONS INC GW-USFang300 MAC1 driver

1. Download the setup file for PLANEX COMMUNICATIONS INC GW-USFang300 MAC1 driver from the location below. This is the download link for the driver version 1027.4.1120.2014 released on 2015-02-16.
2.  
3. Start the driver installation file from a Windows account with the highest privileges (rights). If your UAC (User Access Control) is started then you will have to accept of the driver and run the setup with administrative rights.
4.  
5. Follow the driver installation wizard, which should be pretty straightforward. The driver installation wizard will analyze your PC for compatible devices and will install the driver.
6.  
7. Shutdown and restart your computer and enjoy the fresh driver, it is as simple as that.
8.  

This driver is digitally signed by PLANEX COMMUNICATIONS INC.
Driver file size: 1572708 bytes (1.50 MB)
Driver rating 4.4 stars out of 55460 votes.
This driver is compatible with the following versions of Windows:

• This driver works on Windows 8.1 32 bits
• This driver works on Windows 10 32 bits
• This driver works on Windows 11 32 bits

2. How to use DriverMax to install PLANEX COMMUNICATIONS INC GW-USFang300 MAC1 driver

The advantage of using DriverMax is that it will install the driver for you in just a few seconds and it will keep each driver up to date. How can you install a driver with DriverMax? Let's follow a few steps!

1. Start DriverMax and push on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your computer.
2.  
3. Take a look at the list of available driver updates. Search the list until you find the PLANEX COMMUNICATIONS INC GW-USFang300 MAC1 driver. Click the Update button.
4.  
5. Enjoy using the updated driver! :)
6.