Driver for PLANEX COMMUNICATIONS INC GW-USFang300 MAC1 - downloading and installing it

GW-USFang300 MAC1 is a Network Adapters device. This Windows driver was developed by PLANEX COMMUNICATIONS INC. The hardware id of this driver is USB/VID_2019&PID_4903&MI_01.

1. PLANEX COMMUNICATIONS INC GW-USFang300 MAC1 driver - how to install it manually

1. Download the driver setup file for PLANEX COMMUNICATIONS INC GW-USFang300 MAC1 driver from the link below. This download link is for the driver version 1027.1.0902.2014 released on 2014-10-13.
2.  
3. Run the driver setup file from a Windows account with the highest privileges (rights). If your User Access Control Service (UAC) is running then you will have to confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Go through the driver setup wizard, which should be quite straightforward. The driver setup wizard will analyze your PC for compatible devices and will install the driver.
6.  
7. Restart your PC and enjoy the new driver, as you can see it was quite smple.
8.  

This driver is digitally signed.
Download size of the driver: 1658303 bytes (1.58 MB)
Driver rating 4.1 stars out of 97492 votes.
This driver is fully compatible with the following versions of Windows:

• This driver works on Windows 8 64 bits
• This driver works on Windows 8.1 64 bits
• This driver works on Windows 10 64 bits
• This driver works on Windows 11 64 bits

2. The easy way: using DriverMax to install PLANEX COMMUNICATIONS INC GW-USFang300 MAC1 driver

The most important advantage of using DriverMax is that it will setup the driver for you in the easiest possible way and it will keep each driver up to date, not just this one. How easy can you install a driver using DriverMax? Let's see!

1. Start DriverMax and press on the yellow button named ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your computer.
2.  
3. Take a look at the list of available driver updates. Search the list until you find the PLANEX COMMUNICATIONS INC GW-USFang300 MAC1 driver. Click on Update.
4.  
5. Finished installing the driver!
6.