Emulex Emulex OneConnect OCm10102-I-SP1, NIC/TOE how to download and install the driver

Emulex OneConnect OCm10102-I-SP1, NIC/TOE is a Network Adapters hardware device. This Windows driver was developed by Emulex. The hardware id of this driver is PCI/VEN_19A2&DEV_0700&SUBSYS_E65610DF.

1. How to manually install Emulex Emulex OneConnect OCm10102-I-SP1, NIC/TOE driver

1. Download the driver setup file for Emulex Emulex OneConnect OCm10102-I-SP1, NIC/TOE driver from the location below. This download link is for the driver version 10.2.506.4 dated 2014-12-19.
2.  
3. Run the driver setup file from a Windows account with the highest privileges (rights). If your User Access Control Service (UAC) is running then you will have to confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Follow the driver setup wizard, which should be quite straightforward. The driver setup wizard will scan your PC for compatible devices and will install the driver.
6.  
7. Shutdown and restart your PC and enjoy the updated driver, it is as simple as that.
8.  

This driver is digitally signed by Emulex.
Size of this driver: 616520 bytes (602.07 KB)
This driver received an average rating of 4 stars out of 49638 votes.
This driver will work for the following versions of Windows:

• This driver works on Windows 8 64 bits
• This driver works on Windows 8.1 64 bits
• This driver works on Windows 10 64 bits
• This driver works on Windows 11 64 bits

2. How to use DriverMax to install Emulex Emulex OneConnect OCm10102-I-SP1, NIC/TOE driver

The advantage of using DriverMax is that it will setup the driver for you in just a few seconds and it will keep each driver up to date. How can you install a driver with DriverMax? Let's take a look!

1. Open DriverMax and push on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your computer.
2.  
3. Take a look at the list of available driver updates. Search the list until you locate the Emulex Emulex OneConnect OCm10102-I-SP1, NIC/TOE driver. Click the Update button.
4.  
5. Finished installing the driver!
6.