Emulex Emulex OneConnect OCm10102-I-M, NIC/TOE - two ways of downloading and installing the driver

Emulex OneConnect OCm10102-I-M, NIC/TOE is a Network Adapters hardware device. This Windows driver was developed by Emulex. The hardware id of this driver is PCI/VEN_19A2&DEV_0700&SUBSYS_E65210DF.

1. Install Emulex Emulex OneConnect OCm10102-I-M, NIC/TOE driver manually

1. Download the driver setup file for Emulex Emulex OneConnect OCm10102-I-M, NIC/TOE driver from the location below. This is the download link for the driver version 4.2.390.6 dated 2012-10-25.
2.  
3. Start the driver setup file from a Windows account with the highest privileges (rights). If your User Access Control (UAC) is started then you will have to accept of the driver and run the setup with administrative rights.
4.  
5. Follow the driver setup wizard, which should be pretty straightforward. The driver setup wizard will analyze your PC for compatible devices and will install the driver.
6.  
7. Shutdown and restart your PC and enjoy the fresh driver, as you can see it was quite smple.
8.  

This driver is digitally signed by the manufacturer.
Driver file size: 422524 bytes (412.62 KB)
This driver was installed by many users and received an average rating of 4.3 stars out of 88425 votes.
This driver is fully compatible with the following versions of Windows:

• This driver works on Windows 8 64 bits
• This driver works on Windows 8.1 64 bits
• This driver works on Windows 10 64 bits
• This driver works on Windows 11 64 bits

2. How to use DriverMax to install Emulex Emulex OneConnect OCm10102-I-M, NIC/TOE driver

The advantage of using DriverMax is that it will setup the driver for you in just a few seconds and it will keep each driver up to date, not just this one. How can you install a driver with DriverMax? Let's see!

1. Start DriverMax and press on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your computer.
2.  
3. Take a look at the list of driver updates. Scroll the list down until you locate the Emulex Emulex OneConnect OCm10102-I-M, NIC/TOE driver. Click on Update.
4.  
5. Enjoy using the updated driver! :)
6.