Emulex Emulex OneConnect OCm10102-F-HDS, NIC/TOE driver download and installation

Emulex OneConnect OCm10102-F-HDS, NIC/TOE is a Network Adapters device. The developer of this driver was Emulex. PCI/VEN_19A2&DEV_0700&SUBSYS_E61410DF is the matching hardware id of this device.

1. Manually install Emulex Emulex OneConnect OCm10102-F-HDS, NIC/TOE driver

1. Download the driver setup file for Emulex Emulex OneConnect OCm10102-F-HDS, NIC/TOE driver from the location below. This is the download link for the driver version 4.2.390.6 dated 2012-10-25.
2.  
3. Start the driver installation file from a Windows account with the highest privileges (rights). If your User Access Control (UAC) is enabled then you will have to confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Follow the driver setup wizard, which should be pretty easy to follow. The driver setup wizard will analyze your PC for compatible devices and will install the driver.
6.  
7. Restart your PC and enjoy the updated driver, it is as simple as that.
8.  

Emulex applied a digital signature to this driver.
The file size of this driver is 422524 bytes (412.62 KB)
Driver rating 4.5 stars out of 43415 votes.
This driver is compatible with the following versions of Windows:

• This driver works on Windows 8 64 bits
• This driver works on Windows 8.1 64 bits
• This driver works on Windows 10 64 bits
• This driver works on Windows 11 64 bits

2. How to install Emulex Emulex OneConnect OCm10102-F-HDS, NIC/TOE driver using DriverMax

The most important advantage of using DriverMax is that it will setup the driver for you in just a few seconds and it will keep each driver up to date. How can you install a driver with DriverMax? Let's take a look!

1. Start DriverMax and push on the yellow button named ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your computer.
2.  
3. Take a look at the list of detected driver updates. Scroll the list down until you find the Emulex Emulex OneConnect OCm10102-F-HDS, NIC/TOE driver. Click the Update button.
4.  
5. That's all, the driver is now installed!
6.