Driver for Emulex Emulex OneConnect OCe10102-I-HP, NIC/TOE - downloading and installing it

Emulex OneConnect OCe10102-I-HP, NIC/TOE is a Network Adapters device. This driver was developed by Emulex. PCI/VEN_19A2&DEV_0700&SUBSYS_1749103C is the matching hardware id of this device.

1. How to manually install Emulex Emulex OneConnect OCe10102-I-HP, NIC/TOE driver

1. Download the setup file for Emulex Emulex OneConnect OCe10102-I-HP, NIC/TOE driver from the link below. This download link is for the driver version 10.2.506.4 released on 2014-12-19.
2.  
3. Start the driver setup file from a Windows account with the highest privileges (rights). If your UAC (User Access Control) is enabled then you will have to confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Follow the driver setup wizard, which should be quite easy to follow. The driver setup wizard will analyze your PC for compatible devices and will install the driver.
6.  
7. Restart your PC and enjoy the updated driver, as you can see it was quite smple.
8.  

Emulex applied a digital signature to this driver.
Size of this driver: 616520 bytes (602.07 KB)
This driver was rated with an average of 4.9 stars by 51170 users.
This driver will work for the following versions of Windows:

• This driver works on Windows 8 64 bits
• This driver works on Windows 8.1 64 bits
• This driver works on Windows 10 64 bits
• This driver works on Windows 11 64 bits

2. How to install Emulex Emulex OneConnect OCe10102-I-HP, NIC/TOE driver using DriverMax

The advantage of using DriverMax is that it will setup the driver for you in just a few seconds and it will keep each driver up to date, not just this one. How easy can you install a driver with DriverMax? Let's take a look!

1. Open DriverMax and push on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your computer.
2.  
3. Take a look at the list of available driver updates. Search the list until you find the Emulex Emulex OneConnect OCe10102-I-HP, NIC/TOE driver. Click on Update.
4.  
5. That's all, the driver is now installed!
6.