Emulex Emulex OneConnect OCe10102-F, NIC/TOE - two ways of downloading and installing the driver

Emulex OneConnect OCe10102-F, NIC/TOE is a Network Adapters hardware device. This Windows driver was developed by Emulex. In order to make sure you are downloading the exact right driver the hardware id is PCI/VEN_19A2&DEV_0700&SUBSYS_E60210DF.

1. Manually install Emulex Emulex OneConnect OCe10102-F, NIC/TOE driver

1. Download the setup file for Emulex Emulex OneConnect OCe10102-F, NIC/TOE driver from the location below. This is the download link for the driver version 10.0.718.26 released on 2014-01-02.
2.  
3. Start the driver installation file from a Windows account with the highest privileges (rights). If your User Access Control (UAC) is running then you will have to confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Go through the driver setup wizard, which should be quite straightforward. The driver setup wizard will scan your PC for compatible devices and will install the driver.
6.  
7. Restart your computer and enjoy the fresh driver, as you can see it was quite smple.
8.  

This driver is digitally signed.
The file size of this driver is 644257 bytes (629.16 KB)
This driver was installed by many users and received an average rating of 4.3 stars out of 20858 votes.
This driver will work for the following versions of Windows:

• This driver works on Windows 8 64 bits
• This driver works on Windows 8.1 64 bits
• This driver works on Windows 10 64 bits
• This driver works on Windows 11 64 bits

2. How to use DriverMax to install Emulex Emulex OneConnect OCe10102-F, NIC/TOE driver

The advantage of using DriverMax is that it will setup the driver for you in just a few seconds and it will keep each driver up to date, not just this one. How can you install a driver with DriverMax? Let's follow a few steps!

1. Open DriverMax and click on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your PC.
2.  
3. Take a look at the list of detected driver updates. Search the list until you locate the Emulex Emulex OneConnect OCe10102-F, NIC/TOE driver. Click the Update button.
4.  
5. Enjoy using the updated driver! :)
6.