Download and install Emulex Emulex OneConnect OCe10102-F-FTS, NIC/TOE driver

Emulex OneConnect OCe10102-F-FTS, NIC/TOE is a Network Adapters device. This Windows driver was developed by Emulex. In order to make sure you are downloading the exact right driver the hardware id is PCI/VEN_19A2&DEV_0700&SUBSYS_11881734.

1. Emulex Emulex OneConnect OCe10102-F-FTS, NIC/TOE - install the driver manually

1. You can download from the link below the driver installer file for the Emulex Emulex OneConnect OCe10102-F-FTS, NIC/TOE driver. The archive contains version 10.5.121.7 dated 2015-05-30 of the driver.
2.  
3. Run the driver installer file from a user account with the highest privileges (rights). If your User Access Control (UAC) is running please accept of the driver and run the setup with administrative rights.
4.  
5. Go through the driver installation wizard, which will guide you; it should be pretty easy to follow. The driver installation wizard will scan your computer and will install the right driver.
6.  
7. When the operation finishes restart your computer in order to use the updated driver. As you can see it was quite smple to install a Windows driver!
8.  

Emulex applied a digital signature to this driver.
Size of this driver: 573229 bytes (559.79 KB)
Driver rating 4.9 stars out of 73115 votes.
This driver is fully compatible with the following versions of Windows:

• This driver works on Windows 7 64 bits

2. How to use DriverMax to install Emulex Emulex OneConnect OCe10102-F-FTS, NIC/TOE driver

The most important advantage of using DriverMax is that it will setup the driver for you in just a few seconds and it will keep each driver up to date, not just this one. How easy can you install a driver using DriverMax? Let's take a look!

1. Start DriverMax and push on the yellow button named ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your PC.
2.  
3. Take a look at the list of detected driver updates. Scroll the list down until you find the Emulex Emulex OneConnect OCe10102-F-FTS, NIC/TOE driver. Click on Update.
4.  
5. That's it, you installed your first driver!
6.