DisplayLink DisplayLink Network Adapter NCM driver download and installation

DisplayLink Network Adapter NCM is a Network Adapters hardware device. The developer of this driver was DisplayLink. USB/VID_17E9&PID_43B9&MI_05 is the matching hardware id of this device.

1. DisplayLink DisplayLink Network Adapter NCM - install the driver manually

1. You can download from the link below the driver setup file for the DisplayLink DisplayLink Network Adapter NCM driver. The archive contains version 8.3.1728.0 dated 2017-06-27 of the driver.
2.  
3. Start the driver installer file from a user account with administrative rights. If your User Access Control Service (UAC) is running please accept of the driver and run the setup with administrative rights.
4.  
5. Go through the driver setup wizard, which will guide you; it should be pretty easy to follow. The driver setup wizard will scan your PC and will install the right driver.
6.  
7. When the operation finishes shutdown and restart your computer in order to use the updated driver. As you can see it was quite smple to install a Windows driver!
8.  

This driver is digitally signed by DisplayLink.
The file size of this driver is 69436 bytes (67.81 KB)
This driver received an average rating of 5 stars out of 23190 votes.
This driver is fully compatible with the following versions of Windows:

• This driver works on Windows 7 64 bits
• This driver works on Windows 8 64 bits
• This driver works on Windows 8.1 64 bits
• This driver works on Windows 10 64 bits
• This driver works on Windows 11 64 bits

2. How to install DisplayLink DisplayLink Network Adapter NCM driver using DriverMax

The most important advantage of using DriverMax is that it will setup the driver for you in just a few seconds and it will keep each driver up to date, not just this one. How can you install a driver with DriverMax? Let's follow a few steps!

1. Start DriverMax and click on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your computer.
2.  
3. Take a look at the list of available driver updates. Scroll the list down until you find the DisplayLink DisplayLink Network Adapter NCM driver. Click the Update button.
4.  
5. That's all, the driver is now installed!
6.