DisplayLink DisplayLink Network Adapter NCM - two ways of downloading and installing the driver

DisplayLink Network Adapter NCM is a Network Adapters device. The developer of this driver was DisplayLink. In order to make sure you are downloading the exact right driver the hardware id is USB/VID_17E9&PID_4391&MI_05.

1. Manually install DisplayLink DisplayLink Network Adapter NCM driver

1. Download the driver setup file for DisplayLink DisplayLink Network Adapter NCM driver from the link below. This download link is for the driver version 8.5.2891.0 dated 2018-02-15.
2.  
3. Run the driver installation file from a Windows account with the highest privileges (rights). If your User Access Control Service (UAC) is running then you will have to accept of the driver and run the setup with administrative rights.
4.  
5. Follow the driver installation wizard, which should be quite straightforward. The driver installation wizard will scan your PC for compatible devices and will install the driver.
6.  
7. Restart your computer and enjoy the updated driver, as you can see it was quite smple.
8.  

DisplayLink applied a digital signature to this driver.
File size of the driver: 69939 bytes (68.30 KB)
This driver was rated with an average of 5 stars by 57176 users.
This driver is fully compatible with the following versions of Windows:

• This driver works on Windows 7 64 bits
• This driver works on Windows 8 64 bits
• This driver works on Windows 8.1 64 bits
• This driver works on Windows 10 64 bits
• This driver works on Windows 11 64 bits

2. How to install DisplayLink DisplayLink Network Adapter NCM driver using DriverMax

The most important advantage of using DriverMax is that it will install the driver for you in just a few seconds and it will keep each driver up to date. How can you install a driver using DriverMax? Let's see!

1. Open DriverMax and push on the yellow button named ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your PC.
2.  
3. Take a look at the list of detected driver updates. Scroll the list down until you locate the DisplayLink DisplayLink Network Adapter NCM driver. Click the Update button.
4.  
5. Finished installing the driver!
6.